ADDING TEETH

 STEP ONE

 This picture is very beautiful but one teeth is little bit broken which is not looking good. So in this tutorial we will correct the teeth so the picture looks more beautiful. First step is to open the image in Photoshop. Duplicate the background layer (short key CTRL+J). Now right click on the pen tool and select the freeform pen tool and make sure that paths are selected and caps are off.

 STEP TWO

  Using the free form pen tool click on the sides of the teeth and make a selection  as shown in the figure and if you want to change this selection then  keep pressing  ctrl and then drag and drop any point of path to a place in order to correct them. When the two ends of the path meet it become same as in the figure

 STEP THREE

 Right click on the path which we have for selection and then click on it to make selection. Select feather radius at o and then press ok

STEP FOUR

Now select the smudge tool and make the size of the brush small so that it easily come inside the selection, after that click in the circle and drag it out side where the teeth is broken as in the figure after that press Ctrl+D to deselect.

FINAL RESULTS